M800 elektrinė pavara karštam vandeniui

Pradžia/Prekių katalogas/Pavaros ir vožtuvai/Elektrinės pavaros/M800 elektrinė pavara karštam vandeniui

M800 elektrinė pavara karštam vandeniui

Prekės kodas: 8800310030 Kategorija:

TACPaskirtis: karštam vandeniui

Kaina su PVM: 477,95 €

395,00 + PVM

Čia pateikiamos mažmeninės prekių kainos. Siųskite mums užklausą ir gausite asmeninį pasiūlymą.

Turime sandėlyje!

Prekę pristatysime per 1 d.d. (užsakius iki 12:00).

Aprašymas

M800 elektrinė pavara karštam vandeniui, kodas 8800310030.

Tai daugiafunkcinė elektro-mechaninė pavara dvieigio ar trieigio vožtuvo valdymui, skirta karšto vandens arba vėdinimo sistemoms.

M800 yra dvieigė arba trieigė elektromecheninė vožtuvo valdymo pavara:

  • buitinio karšto vandens sistemai
  • šildymo sistemai
  • vėdinimo sistemai

M800 yra skirta kontroliuojamo signalo padidinimui / sumažinimui arba moduliacinio 0-10 V signalo valdymui.
Tolygus valdymas leidžia pasiekti greitesnį pavaros pozicionavimą.

M800 is either controlled by an increase/decrease signal or by a modulating 0–10 V control signal. Modulating control makes for a faster positioning of the actuator.

FUNCTION

The actuator M800
The brushless DC-motor of the actuator turns a screw via a gear wheel. The motor receives a control signal from a controller. The screw gets a linear movement which moves the stem of the valve.

Control signal
M800 can either be controlled by an increase / decrease signal or by a variable direct voltage. If an increase/decrease signal is used, the actuator normally moves inwards on an increase signal and outwards on a decrease signal, see Settings.

Manual operation
There is a manual operation handle on the actuator. When it is lowered, the motor stops. Then, the actuator can be operated manually if the handle is turned. The actuator is supplied with the manual operation lowered.

Position feedback
Forta actuators are equipped with a 2–10 V DC position feedback signal, where 2 V always corresponds to the closed position and 10 V to the open position.

End point switches
When actuators are controlled in sequence, it is possible to use the end point switches that have set positions. They will toggle when the valve is fully open or fully closed, respectively.

Papildoma informacija

Paskirtis

Karštam vandeniui

Gamintojas

TAC

Susiję straipsniai

Susiję produktai

Title

Go to Top